Nuclear technology
Nuclear fusion: principle, potential and challenges
Builds on: Nuclear fundamentals (mass and energy in the nucleus) and Fission and nuclear fuels (fission).
In a nutshell
Nuclear fusion joins light nuclei, such as the hydrogen isotopes deuterium and tritium, into a heavier one, releasing energy as it does in the Sun. On Earth it needs fuel heated to over 100 million °C, a state called plasma, which must be confined either by magnetic fields (tokamaks such as ITER) or by rapid laser compression (NIF). Experiments have released more energy than was delivered to the fuel, but no fusion power plant yet produces electricity.
Heat fuelPlasmaConfine itFusion
"US laser lab sets fusion record: 8.6 MJ out from 2.08 MJ in" (2025)
If fusion "works", why does no power station run on it? The record is real; so is the gap between a laboratory result and electricity.
Two ways to release nuclear energy
Fission releases energy by splitting a heavy nucleus. There is another way. Instead of splitting a heavy nucleus, two light nuclei can be combined into a heavier one. This is nuclear fusion, the process that powers the Sun and other stars.
Why is energy released? The mass of the products is slightly less than the total mass of the original nuclei, and this difference is released as energy according to Einstein's E = mc². Both fission and fusion release nuclear energy this way, but by opposite processes.
Deuterium and tritium are isotopes of hydrogen. Deuterium has one proton and one neutron; tritium has one proton and two neutrons and is radioactive. In the fusion reaction most experiments aim for, they combine to give helium, a neutron and energy.
Why fusion matters: fusion compared with fission
| Dimension | Nuclear fission | Nuclear fusion |
|---|---|---|
| Principle | Splitting heavy nuclei | Combining light nuclei |
| Fuel | Uranium, plutonium-based fuel | Mainly deuterium and tritium in today's major experiments |
| Fuel availability | Uranium is limited; breeding can extend it | Deuterium is abundant in water; tritium is scarce and must be produced, possibly from lithium |
| Carbon emissions | Low over the life cycle | Potentially low over the life cycle |
| Electricity generation | Commercially established | Not yet achieved |
| Safety | Chain reaction must be controlled, and cooling continued after shutdown | No chain reaction; if the extreme conditions are lost, the reaction simply stops |
| Radioactive waste | Spent fuel and long-lived waste | No spent fuel, but neutrons make reactor materials radioactive, and tritium must be managed |
| Main challenge | Cost, construction time, safety, waste | Sustained net energy and economical electricity |
| Relevance for India now | Established low-carbon electricity | Long-term research |
This is why fusion is attractive, and also why fission still provides all commercial nuclear electricity.
Why is fusion so hard on Earth?
Hydrogen nuclei are positively charged, and like charges repel. For fusion, the nuclei must come close enough for the strong nuclear force to take over, which needs them to move extremely fast, that is, extremely high temperatures. In the Sun, immense gravitational pressure helps. On Earth we cannot reproduce that pressure, so experiments heat the fuel to far higher temperatures instead: around 100–150 million °C, several times hotter than the Sun's core.
At such temperatures, electrons are stripped from atoms, leaving a mixture of charged ions and free electrons. This ionised gas is plasma. No ordinary container can touch it. So the technological challenge is twofold:
- create the conditions for fusion; and
- confine the plasma long enough for enough fusion reactions to occur.
The two main technologies are two answers to the second problem.
Magnetic confinement: the tokamak
Because plasma is made of charged particles, magnetic fields can steer it. A tokamak uses powerful magnetic fields to hold hot plasma in a doughnut-shaped (toroidal) chamber, keeping it away from the walls while fusion takes place.
A tokamak is a confinement device, not a kind of fuel. Its main engineering challenge is keeping the plasma hot, dense and stable for long enough, while the machine withstands intense heat and particle loads.
Inertial confinement: the laser method
The other approach does not try to hold the plasma for long at all. A tiny capsule of fusion fuel is hit by intense laser energy, which compresses and heats it so rapidly that fusion occurs before the fuel has time to fly apart. Its own inertia holds it together for that instant, hence the name.
| Feature | Magnetic confinement | Inertial confinement |
|---|---|---|
| Principle | Magnetic fields hold hot plasma | Lasers rapidly compress and heat a fuel capsule |
| Technology | Tokamak | Laser-driven fusion |
| Example | ITER (France) | National Ignition Facility (NIF), USA |
| Main challenge | Sustaining stable plasma and handling heat | Efficient, rapidly repeated ignition |
ITER
The International Thermonuclear Experimental Reactor (ITER) is being built at Cadarache in southern France to demonstrate that fusion energy is scientifically and technologically feasible at large scale.
| Feature | ITER |
|---|---|
| Technology | Tokamak (magnetic confinement) |
| Planned fuel | Deuterium and tritium |
| Location | Southern France |
| Members | European Union, India, China, Japan, South Korea, Russia and the United States |
| Goal | About 500 MW of fusion power from 50 MW of heating power put into the plasma, a gain of 10 |
| Schedule (revised 2024) | Research operations from 2034; deuterium–tritium operation from 2039 |
ITER is an experiment, not a power station. Its 500 MW is fusion power in the plasma; it will not supply electricity to any grid. India, a full member, supplies major components and systems (including the cryostat, the giant vessel that surrounds the machine) through ITER-India at the Institute for Plasma Research, Gandhinagar. This builds Indian capability in superconducting magnets, cryogenics, plasma technology and advanced materials. India also runs its own tokamaks, Aditya and SST-1, at the same institute.
NIF and what "energy gain" really means
The National Ignition Facility at Lawrence Livermore National Laboratory in the US uses laser-driven inertial confinement. In December 2022 it achieved ignition for the first time: the fusion reaction released more energy (about 3.15 MJ) than the laser energy delivered to the target (2.05 MJ). It has since repeated this several times, and on 7 April 2025 set a record of 8.6 MJ from 2.08 MJ, a target gain of about 4.
Does this mean commercially viable fusion has arrived? No. Three levels must be kept apart:
- Target gain: fusion energy released exceeds the energy delivered to the fuel. NIF has achieved this.
- Facility gain: useful energy out exceeds all the energy used to run the facility. Not achieved: NIF's lasers draw far more electricity from the grid than the 2 MJ they deliver to the target.
- Commercial electricity: a plant that repeatedly and reliably turns fusion energy into electricity at an affordable cost. Not achieved anywhere.
This is the most important distinction to carry into any reading of a fusion "breakthrough" headline.
Consolidation
Fusion releases energy by combining light nuclei, the opposite of fission. The hard part is not starting fusion but sustaining and controlling it so that it produces useful net energy. Tokamaks such as ITER use magnetic confinement; laser facilities such as NIF use inertial confinement. Both show real scientific progress, but materials that survive intense neutron bombardment, a supply of tritium, ways to extract heat, and continuous affordable operation remain unsolved. Fusion is a promising long-term technology, not an immediate alternative to fission.
Recent developments
NIF sets a fusion record: 8.6 MJ out from 2.08 MJ of laser energy
The National Ignition Facility in the US produced 8.6 megajoules of fusion energy from 2.08 megajoules of laser energy delivered to the target, a target gain of about 4.1.
Why it matters: It more than doubles NIF's first ignition result of December 2022 (3.15 MJ from 2.05 MJ) and shows ignition can be repeated.
Remember: The gain is measured at the target. Powering the lasers draws roughly 300 MJ from the grid, so no fusion device yet produces net electricity.
Source: Lawrence Livermore National Laboratory annual report 2025
ITER resets its schedule: research operations from 2034
ITER's new baseline targets the start of research operations in 2034 and deuterium-tritium operation in 2039. The earlier 2016 plan had aimed for first plasma in 2025.
Why it matters: Notes saying ITER would be complete by 2025 are out of date.
Remember: ITER is a research device, not a power plant. It is in southern France, and India is a member.
Source: ITER Organization, Jul 2024
Last-month notes
- Fusion: light nuclei combine (D + T → helium + neutron + energy). Deuterium: 1 proton, 1 neutron; tritium: 1 proton, 2 neutrons, radioactive.
- Plasma: ionised gas; fusion experiments run at about 100–150 million °C.
- Magnetic confinement: tokamak; ITER (Cadarache, France; members EU, India, China, Japan, South Korea, Russia, US; 500 MW fusion from 50 MW heating; research operations 2034, D–T 2039).
- Inertial confinement: lasers; NIF (US): ignition Dec 2022; record 8.6 MJ from 2.08 MJ (Apr 2025).
- India: ITER member; Institute for Plasma Research, Gandhinagar; tokamaks Aditya and SST-1.
Statements to watch for
- Target gain is not facility gain, and neither is electricity generation.
- ITER will not supply electricity to the grid.
- A tokamak is a device, not a fuel.
- Fusion produces no spent fuel but does produce radioactive (activated) materials.
Revise and apply
Activities to check your understanding, not new content. Answer first, then press Check or Show answers. Multiple-choice questions are original, in the UPSC style, not past UPSC questions. A printable workbook with all activities is on the theme page.
Type the missing words, then check.
(a) join (b) tritium (c) helium (d) 100-150 (e) plasma (f) tokamak (g) iter (h) sst-1 (i) lasers (j) nif (k) target (l) electricity
- Fusion releases energy because the products weigh slightly than the inputs.
- Deuterium is abundant in ; tritium could be bred from .
- ITER aims for 500 MW of fusion power from MW of heating.
- India supplies ITER's through ITER-India.
- NIF first achieved ignition in 2022.
1. less · 2. water; lithium · 3. 50 · 4. cryostat · 5. december
Pick the odd one out in each set.
1. NIF: laser (inertial) confinement; the others are magnetic. 2. Uranium: a fission fuel; lithium is used to breed tritium. 3. Brazil: not an ITER member.
- ITER will supply 500 MW of electricity to the French grid. 500 MW is fusion power; ITER is an experiment with no grid supply.
- NIF produces more energy than the whole facility consumes. Only target gain; the lasers draw far more from the grid.
- Fusion produces no radioactive material at all. Neutrons make reactor materials radioactive, and tritium is radioactive.
- If plasma conditions are lost, the fusion reaction simply stops.
1. False: 500 MW is fusion power; ITER is an experiment with no grid supply. 2. False: Only target gain; the lasers draw far more from the grid. 3. False: Neutrons make reactor materials radioactive, and tritium is radioactive. 4. True.
"US laser lab sets fusion record: 8.6 MJ out from 2.08 MJ in." (a) Which confinement method? (b) What kind of gain is this? (c) Does it mean fusion electricity is close?
(a) Inertial (laser) confinement at NIF. (b) Target gain: energy out exceeds laser energy delivered to the fuel. (c) No: facility gain and affordable electricity remain unachieved.
With reference to ITER, consider the following statements:
- It uses lasers to compress a small fuel capsule.
- India is a member of the project.
- It is designed to supply 500 MW of electricity to the French grid.
Which of the statements given above is/are correct?
Answer: (a). ITER is a tokamak (magnetic confinement); lasers are NIF's method. Its 500 MW is fusion power in the plasma, not electricity.
What it tests: the two confinement methods, and fusion power versus electricity.
The National Ignition Facility's "ignition" experiments are significant because they showed that:
Answer: (b). This is target gain only. The facility's lasers use far more energy than they deliver, so (c) is wrong, and each shot lasts a tiny fraction of a second, so (d) is wrong.
What it tests: the three levels of energy gain.
Why do fusion experiments on Earth need temperatures far higher than those in the core of the Sun?
Answer: (b). Without that pressure, higher temperatures must make the nuclei move fast enough to overcome their electrical repulsion. Hydrogen isotopes are positively charged, so (d) is wrong.
What it tests: the physical reason fusion is hard.
Why is fusion promising, yet not an immediate alternative to fission?
Points to include: Promise: abundant fuel, no chain reaction, no spent fuel, low emissions. Barriers: sustaining 100-million-degree plasma, materials that survive neutron bombardment, tritium supply, net energy at facility level, affordable electricity.
What does India gain from participating in ITER?
Points to include: Access to frontier fusion science; Indian industry builds major components (the cryostat), gaining skills in superconducting magnets, cryogenics, plasma technology and materials; a stake in future fusion power for a modest share of cost.
The next question The same technologies that make electricity can also make weapons. How does the world keep the two apart, and where does India stand?